Chitongda YL-007M2 Manual de usuario descargar pdf (Pagina 9)

LCD display:

3. Exit Settings

Press [*] and [#] buttons, the main unit emits a long beep and exits

settings. The [SET] indicator goes out and the system returns to disarm

state.

Operating method: 【*】【#】

4. Factory Reset

In disarm status, use keypad to input [95175308246] and press [#] to

confirm, all the LED indicators will be on for 2 seconds and you will

hear a long beep. The main unit gets all its settings cleared and restores

to its factory settings successfully.

Operating method: [95175308246] + [#]

5. Coding of Remote Controller

Extra remote controller has to be code to the alarm host in order to

perform normally. The one in the standard package has been coded.

In setup state, use keypad to input [20], input the remote controller

number [1~8], and then press [#] to confirm. The main unit emits a long

beep and you will hear “remote control coding”. The [ ] indicator is

on without flashing; press any button on the wireless remote controller,

the main unit makes a long beep and you will hear “coding completed”,

[ ] indicator goes out, indicating the remote controller succeeds in

coding.

Operating method: [20]  [A]  [#]

A indicates: 1~8 remote controllers number. You can add maximum 8

remote controllers.

LCD display:

6. Delete Remote Controller

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Sin comentarios

Chitongda YL-007M2 Manual de usuario Pagina 9